Mongoose Cyborg Start User Manual download pdf (Page 13)

Installation Manual

CYBORG START

*! WARNING! It Is Recommended always use the Handbrake Controlled Ignition Support ON

mode. Enabling the Handbrake Controlled Ignition Support OFF mode is realized under

responsibility of user solely.

When enabling the Handbrake Controlled Ignition Support OFF mode take necessary measures,

guaranteeing stillness of car during remote (automatic) start the engine, as well as for the whole

time of parking!

Detecting the Engine has started

*Voltage Detection

The voltage detection method of determining that the engine has started is the default

method, as this does not require any special programming or connections. This method will be

used unless Installer Software Switch 27 RPM Learning is used to teach an engine RPM idle

frequency or 13 Oil/Temperature Warning is set to generator/oil lamp detection.

The following method is used: 

 When an engine start is to be performed, either remote start or automatic, the ignition

support will be switched on.

 The remote start system will learn the average supply voltage during the final 2seconds

of the wait to start period and store this as the wait to start voltage.

 During the starting period, the supply voltage will be monitored and the starter motor

relays will be switched off when the supply voltage reaches either: 

i) 1 Volt less voltage than the wait to start voltage if Installer Software Switch 22 Engine

Start Voltage Sensing Level is set to Low.

ii) 0,5 Volt less voltage than the wait to start voltage if Installer Software Switch 22

Engine Start Voltage Sensing Level is set to high.

**Generator/Oil Lamp Input

The system will simply monitor the lamp signal and when the system detects that the lamp

has switched off (plus 0.5 seconds debounce period) the Remote Start system will turn off the

starter motor.

*** Engine RPM Idle Frequency Learning

The idle frequency of the RPM signal must be taught to the system using Installer Software

Switch 27 RPM Learning as follows:

 Select Installer Software Switch 27 RPM Learning.

 Press buttons 1 and 2 together to enter the RPM learning mode and start the 1minute

timer.

 The siren will beep 3 times and the indicators will flash 3 times to indicate that the learning

mode has been entered and 1minute period of time to start the engine has begun.

Автомобильная охранная система “MONGOOSE” Модель CYBORG START

РУССКИЙ

Подключение встроенного реле стартера с функцией

блокировки стартера и защитой от повторного включе

ния стартера

Подключение датчика разбития стекла

1 2 ... 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Mongoose Cyborg Start User Manual Page 13

Comments to this Manuals

Related products and manuals for Car alarm Mongoose Cyborg Start